What is the maximum SSI bit frame that I can use with the EMCL2 firmware?

What is the maximum SSI bit frame that I can use with the EMCL2 firmware?

The maximum SSI frame that can be used without problems with the EMCL2 firmware is 32 bits in total, including single-turn, multi-turn, error and other extra bits.
Please remember that if the SSI absolute encoder is the only feedback of your system, there are special "SSI only" firmware versions that ensure proper performance in those applications. You can find this special firmware from version 2.6.1 and on in the following link: Downloads.


    • Related Articles

    • How to configure a rotatory brushless motor with SSI encoder feedback

      Problem I have a rotatory brushless motor with an SSI encoder as the only feedback but I don't know how to properly configure it and tune it. What is the right process that I need to follow? Clarifications and checkings This article describes (step ...

    • How to use the Configuration Wizard

      Problem I have just connected to my drive in MotionLab for the first time and I get asked to configure my motor by the following pop-up: How do I have to proceed and how do I get my system fully configured? Let's see what process we need to go ...

    • How to update the firmware of my drive

      Problem I have an Ingenia servo drive connected to my MotionLab software and I don't know how to update its firmware. What do I need to do? Steps Every time that you connect an Ingenia servo drive and it is detected by MotionLab, you will notice a ...

    • How to use the sensorless wizard to configure a motor to run in sensorless mode

      Problem In this How-to guide, we explain how to start up a BLAC motor in sensorless mode making use of the sensorless wizard of MotionLab. This manual has been written and verified using the following version: MotionLab 2.13.2.662 This guide assumes ...

    • How to use the Open-loop mode

      Problem I have my motor (and optional feedback devices) properly configured and I am wondering if I can drive the motor in open-loop mode. Is the Open-loop mode of operation meant to be used in end-applications or does it have a specific purpose that ...